Advertisement
In this case, the Remote Foot Control provides complete
control from the minimum to the maximum output of the
welding power source or welding generator rather than fine
adjustment of the Amperage Adjustment Control setting on
the welding power source or welding generator.
To determine in which way the Remote Foot Control affects
the operation of the welding power source or welding gener-
ator, refer the the welding power source or welding genera-
tor circuit diagram and/or Instruction Manual.
IMPORTANT: When a Remote Foot Control is used, refer to
the Instruction Manual of the welding power source or weld-
ing generator for additional operational information.
4. MAINTENANCE
WARan kill; HOT SURFACES can cause severe burns.
·Do not touch live electrical parts.
·Disconnect plugs from power source before
·inspecting or servicing.
·Allow unit to cool before servicing.
Once each month inspect the Remote Foot Control Cord for
breaks in the insulating jacket particularly at the plug and at
the entrance into the Remote Foot Control housing. Repair
all breaks with electrical tape, or replace the cord if neces-
sary. Refer to T Diagram 5-1 through Diagram 5-2 for proper
cord conductor connections).
Page 04
Advertisement
