Advertisement
1-2. DESCRIPTION
These Remote Foot Controls are designed for use as a re-
mote Amperage control in conjunction with a welding power
source or welding generator having electric amperage and
equipped with remote control facilities.
2-1. LOCATION
The Remote Foot Control is equipped with a sixteen foot
cord (unless otherwise specified) which enables the Remote
Foot Control to be remotely located from the welding power
source or welding generator. If it is necessary to install a
cord of longer length, up to 200 feet (61 m) of similar type
cord may be used. Refer to Table 2-1 for conductor size ac-
cording to the desired length.
2-2. INTERCONNECTIONS
Remote Foot Controls For Remote Amperage
1. If the cord is equipped with a locking cap, fully insert the
cap into the Remote Amperage Control Receptacle on the
welding power source or welding generator and rotate clock-
wise.
2. If the cord is equipped with a power connector, align
keyway, insert plug into receptacle, and rotate threaded col-
lar fully clockwise.
Page 02
Advertisement
