Table of Contents
Advertisement
The top line of the screen displays the names of the Auxiliary devices (the letter A in the lower corner distinguishes this screen
from the Program, Volume, and Transpose screens which are very similar in appearance). Control Sliders 1 through 4 are
used to select the program number that will be issued to each device as the SL-2001 preset is entered (program changes will
be issued as the sliders are adjusted). These program numbers should match the numbers displayed by each actual MIDI
device; if not, the program format was incorrectly entered during device installation (see section 4). If no program change is
desired, adjust the slider until two dashes appear under the device name. To select program numbers for devices five through
eight, use the Star switch to access the alternate screen. Unlike the Program, Volume, and Transpose screens (section 8), the
order of the names has no correlation with the Data Paths. If there are less than five Auxiliary devices, the alternate screen
will not be displayed.
SWITCH MODES
The SL-2001 provides five local switches which may be programmed to perform many useful functions during Perform Mode.
Each switch (A, B, C, Star, and Alpha) may be set for either a momentary response or toggle mode. In Perform Mode the cur-
rent state of all switches is displayed on the SL-2001 front panel. Switches A, B, and C appear in the text display; the Star and
Alpha switches each have LED indicators.
Use Control Slider 1 to select the name of the switch. Control Slider 2 sets the mode (Toggle or Momentary). In Toggle Mode,
a switch will change state every time the footswitch is pressed and released. In Momentary Mode, the switch will change
state when the footswitch is first pressed, and then revert to its original state when the footswitch is released. Control Slider
3 is used to set the initial state of each switch as the preset is entered.
Advertisement
Table of Contents
