Broaster VF-2 Quick Start Manual page 2

b. Re-connect wire to make sure power is now supplied to the controls
7. ENSURE THAT SAFETY PIN IS REMOVED FROM CANISTER AND PIN IS
HANGING SAFELY ON ITS CHAIN
8. Provide a copy of the report to the equipment owner or their designee
a. Make sure to notate any area where additional service is required or
recommended.
9. Date and sign the Semi-Annual and Maintenance log contained in the owner's
Operation Manual
10. Ensure that the unit is properly tagged as being inspected on this date
11. Reset the unit's countdown timer so it will put out a reminder for the next semi-
annual inspection
a. For the Temp-N-Time unit (with the red LED display and the 10-digit
number pad)
i. Press and hold the STOP and #6 button for at least five seconds
ii. If the red Fire System light is illuminated, it will go out and will light
up again in six months as a reminder
b. For the SmartTouch unit (with the touch screen controls) earlier versions
i. Access the Setup Screen using 0540 as the PIN code
ii. Select the Service Contact button
iii. Press the hour counter display, and select YES to reset
iv. If the Inspect Fire System notification is displayed on the Cook
Screen, it will go away, to reappear again in six months
c. For the SmartTouch unit (Later Versions)
i. Access the Setup Screen using the operator's PIN if necessary
ii. Select the Alerts button
iii. Select the hour counter and select YES to reset
iv. If the Inspect Fire System notification is displayed on the Cook
Screen, it will go away, to reappear again in six months
Ensure that any discrepancies that might affect the safe operation of
this unit are resolved before tagging the unit as safe to use.
All of the Broaster parts listed above can be acquired from the local Broaster
Distributor, which can be located at www.broaster.com. Select the "Find a
Distributor" link.