Makita LXRH02 1 Series Technical Information page 21

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-10. Slide levers of Dust extraction system DX01, DX02
DISASSEMBLING
• Slide lever B on Housing L
Remove Rack B and Compression spring 3 in Housing L as drawn in Fig. 67, and then move Slide lever B toward
the upper direction like the arrow mark. (Fig. 67)
Fig. 67
Slide lever B
Compression spring 3
Rack B
Outside of Housing L
(viewed from the opposite)
• Slide lever A on Slide pipe
Remove Collector base A (DX01)/ B (DX02) from Slide pipe by releasing the hooks with a thin-slotted screwdriver,
and then separate Rack A, Compression spring 3, Stopper base and Slide lever A. (Fig. 68)
Fig. 68
Collector
base A/ B
1
3
Hooks to set in the holes
on sides of Slide pipe
Inside of Housing L
Housing L Slotted screwdriver
Housing L
Arrow mark
on Slide lever B
Slide pipe
2
Note: Remove Rack A, Compression spring 3 and Slide lever A
Compression spring 3
in the same way as mentioned in Fig. 67.
P 21/ 25
Stopper base
Slide lever A
Rack A