Makita LXRH02 1 Series Technical Information page 12

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-5. Torsion spring 6 for Connector, Battery housing
ASSEMBLING
See Fig. 35.
Set Torsion spring 6 into Housing L, and then assemble Connector to Compression spring 6. Refer to A .
Set Opener in place. Refer to B .
When Battery housing L and R are matched, do not fail to assemble the parts shown in C .
Fig. 35
C
Battery housing set
Cushion
rubber (R)
Rubber pin 5
Pin 1.5
Cushion rubber (L)
(behind Terminal)
A
Hold one end of Torsion spring 6
with the inner wall of Housing L.
Insert the hinge of Connector
into the coil of Torsion spring 6.
B
Align the chamfered side
of Opener with the walls
of Housing L.
(Housing set)
Cushion
P 12/ 25
Hook the opposite end
of Torsion spring with
the step of Housing L.
Opener