Table of Contents
Advertisement
f.
INT 1
sends calls via:
f
IP1
Back
The connection selected here is used as the standard send connection on this
handset if you briefly press the talk key c after entering the number.
You always have the option of selecting another connection to set up a call. If you
press and hold the talk key c, a list with all available connections is displayed for
¢
selection
(
page
44).
Instead of a specific standard send connection, you can also assign Flexible Choice
to the handset. Each time you make a call, you then have to select the connection
you wish to use on this handset
If other handsets are already registered to the base, you are requested to assign
send and receive connections for the handsets. The following is shown in the dis-
play:
Assign connect. to ?
¤
Perform steps
a.
to
After successfully configuring the settings, you will briefly see the following display:
μ
Connec. assign.
completed
Completing the installation
If you have started the wizard using the message key f, the handset switches to
idle status (an example for the display in idle status):
If the handset is to make calls via a differ-
ent connection/phone number:
¤
g
OK
¤
¢
(
page
45).
f.
for each registered handset.
Press right on the control key v
repeatedly, until the required connec-
tion is displayed (in the example, IP1).
Press the display key
settings.
First steps
§OK§
to save the
33
Advertisement
Chapters
Table of Contents
