Installing The Bagger Top - Toro TITAN ZX Series Operator's Manual

2
Assembling the Bagger Top
Parts needed for this procedure:
1 Bagger top
1 Bagger screen
Procedure
Turn the bagger top over. Install the screen as shown in
Figure 7 so it slopes down toward the collection bags.
Make sure the screens snap into place and the tabs
engage the bagger top.
2
G005666
1. Bagger top
2. Screen
1
3
4
Figure 7
3. Screen tab
4. Slot in bagger top
3

Installing the Bagger Top

Parts needed for this procedure:
1 Circular cotter pin
Procedure
1. Install the bagger top to the bagger frame. Slide
the brackets over the posts in the bagger frame and
install the circular cotter into the hole in the right
hand post (Figure 8). Rotate the bagger top down to
the operating position. The bagger top is easier to
install if two people work together.
Note: To remove the circular cotter, continue to
rotate it in the same direction as installed.
1. Bagger top
2. Bagger frame
3. Bracket, bagger top
6
G016265
Figure 8
4. Circular cotter pin
5. Post