Table of Contents
Advertisement
Fault
Programme does not
start.
Water does enter the
machine or detergent is
hi
d t
t i
not washed away.
not washed away.
8
The
Active" control
light flashes.
Detergent in chamber I is
not washed away.
Water cannot be seen in
drum.
Washing solution is not
g
completely drained. The
l
l d i d Th
H
End" control light
flashes.
Water is flowing out from
underneath the machine.
Foam coming out of the
detergent dispenser.
The programme takes
longer than usual.
All manuals and user guides at all-guides.com
Cause
3
Start" button not pressed.
Water tap not turned on.
Supply hose kinked or trapped.
Strainer in supply hose clogged.
A programme without Prewash was
selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking the pump.
Fluff producing laundry was washed
at a high temperature. The water
drainage pipe or drain hose is
blocked.
The thread of the supply hose is not
tight.
Leak in the drain hose.
To much detergent.
This is not a fault.
The imbalance compensation
system is attempting to balance the
load by distributing the laundry
more evenly.
The foam detection feature has
activated an additional rinsing cycle
to reduce the amount of foam.
Action
3
Press the
Start" button.
Turn on water tap.
Clean the strainer
(refer to Page 17).
Select "K 60 C Cottons +
Linens with Prewash".
Clean the pump (refer to Page 16).
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener
with ½ litre / 1 pt of water and pour
into chamber II of the detergent
dispenser.
Reduce the amount of detergent
next time.
Wash large and small items
together to reduce imbalances.
Add a more appropriate amount of
detergent next time.
19
Advertisement
Table of Contents
