Table of Contents
Advertisement
Available languages
Available languages
Installation & Mounting:
Important! This unit is a safety device, and it must be
connected to its own seperate, fused power point to assure its continued
operation should any other electrical accessory fail.
Carefully remove the beacon and place it on a flat surface. Examine the unit
for transit damage, and locate all parts. If damage is found, or parts are miss-
ing, contact the transit company or ECCO. Do not use damaged or broken
parts.
!
Caution: When drilling into any vehicle surface,
make sure that the area is free from any electrical wires, fuel
lines, vehicle upholstery, etc. that could be damaged.
Permanent Mounting:
Select the desired location on a flat surface for the LED beacon to be mounted.
The visibility of the flash and ease of wiring access should be taken into con-
sideration in the selection of the mounting location.
1.
Using the base gasket as a template, mark the three mounting hole
locations (see Figure 1).
2.
Drill the holes using a 7/32" drill size.
3.
A fourth hole may be drilled for wire access as shown in Figure 1,
or the wires may be routed through the slot in the base for external
access.
4.
Connect the power wires as shown in the wiring section (see Figure
3).
5.
Mount the beacon with #10 hardware.
WARNING!
Failure to follow these instructions can result in fire or injury from excessive heat build up.
Operator is responsible for ensuring cigarette adapter fits correctly into cigarette/auxillary outlet used.
For proper operation, verify cigarette/auxillary outlet circuit is rated to supply, a minimum of 10 amps. (See specifications
section for rated current in amperes).
Do not exceed the current rating for the cigarette lighter power outlet recommended by vehicle manufacturer.
Keep cigarette lighter adapter, and outlet, clean and free of debris.
Do not use the cigarette lighter adapter when wet.
Insert cigarette lighter adapter fully into the outlet for proper connection.
Grasp cigarette lighter adapter, NOT cord, to remove from outlet.
Remove cigarette lighter adapter completely from outlet when light is not in use.
Pipe Mounting:
The 7945 & 7950 series base comes with 1" NPT threads for pipe mounting.
Temporary Mounting, Vacuum-Magnet Mount:
The 7945 & 7950 series beacons are available as vacuum-magnet mount (7945X-
VM & 7950X-VM) units. The Vacuum-Magnet Mount feature includes a suction cup
on the bottom of the beacon, with a magnet inside of the suction cup, for a secure,
temporary mount. The beacon should be placed in the center of the roof where the
least amount of curvature occurs. Before installing, make sure there is no debris on
the bottom of the beacon or on the roof of the vehicle, which could reduce the holding
power of the suction cup and magnet. Place and remove the beacon without sliding
to avoid scratching the paint on the vehicle. After placement, the beacon should
adhere firmly to the surface. If the unit slides or moves easily, a proper installation
has not been obtained. To release the vacuum, lift the tab to release the airlock (see
Figure 2). To protect the Vacuum-Magnet Mount assembly, return beacon to the box
when not in use. Do not attempt to attach the beacon to an ice-covered surface.
WARNING!
!
Maximum recommended vehicle speed for safe operation
using the Vacuum Mount model is 65 mph (104 km/h), when fitted to the
center of a vehicle roof of steel construction. Higher speeds could cause
the mount to fail, resulting in the beacon flying off of the vehicle, which
could cause damage to other vehicles, and injury or death to the passen-
gers. The vacuum-magnet mount is not intended as a permanent mounting
for the beacon. The vacuum-magnet mount unit must be mounted on a flat
smooth magnetic surface (i.e. no fiberglass, ribbed style roofs, etc.). Insure
that the magnet is kept clean.
Figure 2
Page 2 of 12
Advertisement
Table of Contents
