Craftsman 28948 Operator's Manual page 30

REPLACING BATTERY
_,WARNING: Do not short battery terminals
by allowing a wrench or any other object to
contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etco
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hood to raised position.
2o Disconnect BLACKbattery cable (A) then
RED battery cable and carefully remove
battery from tractor.
3_ install new battery with terminals in same
position as old battery.
4. First connect RED battery cable (B) to
positive (+) battery terminal with hex bolt
and keps nut as shown.Tighten securely.
Slide terminal cover (C) over terminal,
5, ConnectBLACKgroundingcabteto neg-
ative (-) battery terminal with remaining
hex bolt and keps nut. Tighten securely_
6. Close hood.
_ _ Negative
(Black)
Cable
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1o Raise hood.
2. Remove bulb holder from the hole inthe
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
, Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3o Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. Whenreplacinghood, besuretoreconnect
the headlight wire connector.
Hood
Headlight Wire
Connector
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmission require removal
for service or replacement, it should be
purged after reinstallation and before op-
erating the tractor. See "PURGE TRANS-
MISSION" in the Operation section of this
manual.
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at
the factory and adjustment should not be
necessary. If adjustment is necessary, see
engine manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthe factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or Ioado If the engine does
need adjustment, see engine manual.
3O