Craftsman 28948 Operator's Manual page 28

TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
1, Park tractor on a level surface, Engage
parking brake,
2. Lower attachment lift lever to its lowest
position°
3, Disengage belt tension rod (K) from lock
bracket (L)o
CAUTION: Belttension rod is spring load-
ed. Have a firm grip on rod and release slowly_
4. Remove screws (P) from R.H_ and L.H.
mandrel covers and remove covers (Q).
5. Remove any dirt or grass clippings which
may have accumulated around mandrels
and entire upper deck surface.
6. Remove belt from electric clutch pulley
(M), both mandrel pulleys (R) and allidler
pulleys (S)o
\
MOWER DRIVE BELT INSTALLATION
1. Install belt around both mandrel pulleys
(R) and around idler pulleys (S) as shown,
2, Install belt onto electric clutch pulley (M).
IMPORTANT: Check belt for proper routing
in all mower pulley grooves.
3. Reassemble R,H, and L,H, mandrel cov-
ers (Q). Securely tighten all screws.
4, Engage bell tension rod (K) on locking
bracket (L).
CAUTION; Belt tension rod is spring load _
ed, Have atightgrip on rod and engage slowly.
5. Raise attb,chment lift lever to highest
position.
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footresL
BELT REMOVAL -
1o Remove mower (See "TO REMOVE
MOWER" in this section of manual).
NOTE: Observe entire motion drive belt and
position of all belt guides and keepers,
2. Disconnect clutch wire harness (A).
3. Remove anti-rotation link (B) on right side
of tractor.
4. Remove beltfrom stationary idler (C) and
clutching idler (D).
5. Pull belt slack toward rear of tractor,
Carefully remove belt upwards from
transmission input pulley and over cool-
ing fan blades (F).
6. Remove belt downward from engine
pulley and around electric clutch (G).
7. Slide belt toward rear of tractor, off the
steering plate (H) and remove from tractor,,
BELT INSTALLATION -
!. Install new belt from tractor rear to front,
over the steering plate (H) and above
clutch brake pedal shaft (J)o
2. Pullbelttowardfrontoftractorand rollbelt
around electric clutch and onto engine
pulley (G).
3. Pull belt toward rear of tractor. Carefully
work belt down around transmission
cooling fan and onto the input pulley (F),
Be sure belt is inside the belt keeper.
4. Install belt through stationary idler (C)
and clutching idler (D).
5. Reinstall anti-rotation link (B) on right
side of tractor, Tighten securely,
6. Reconnect clutch harness (A).
7. Make sure belt is in all pulley grooves
and inside all belt guides and keepers,
8. Install mower (See "TO INSTALL MOW-
ER" in this section of manual).
28