Table of Contents
Advertisement
TROUBLESHOOTING
NOTE: We may charge for service even in the warranty period if your problem is due to the causes listed below.
problem
Oven or grill not working
Oven light not working
Oven not heating enough
There is warm air coming from the top
of the oven door
Clock flashing on display
Unit smoking when first used
Condensation build up
Door cannot be replaced after removal
Functions and temperature appear on
display but oven does not work
When the door is open the fan stops
(underbench only)
When a non fan mode is selected the
fan starts
The light stays on when the door is
closed
The light does not turn *ON* when the
door is opened
possible cause
• Time of day is not set.
• Power is not turned on.
• Controls are incorrectly set
• Oven is in 'Demo' mode, refer to Additional Functionality.
• Household fuse has blown or power supply is off. (If the household fuse
continues to blow, call the Service Centre).
• Child-proof oven lock is activated. 'LOCKED' is displayed when control is
touched. (Refer to operating instructions).
• Light may be turned off at control panel.
• Lamp blown or loose socket.
• Household fuse has blown. (If the household fuse continues to blow, call
the
Service Centre).
• Foil trays on bottom of oven.
• Timer is in 'AUTO' mode. (Refer to operating instructions).
• Household fuse has blown or power supply is off. (If the household fuse
continues to blow, call the Service Centre).
• Oven not pre-heated - pre-heat oven for 30 minutes.
• The oven is located under the control panel. When the oven is on, the
air passes through this vent. This venting is necessary for proper air
circulation in the oven and good baking results. Do not block oven vent.
• Reset time of day and any cooking functions you were using.
• Protective oils being removed.
• Reduce the amount of water used in cooking. (Sometimes condensation
is normal).
• Stirrup not engaged properly.
• Oven is in 'Demo' mode, refer to Additional Functionality.
• This is a function of the power board to help reduce the blast of air when
opening the door.
• Most oven modes have a fast heat up function that uses the fan, fan
element and top (boost) elements. Auto fast heat up can be overridden
by selecting a temperature of 120°C or less, allowing the function to start,
then increasing the temperature to the desired level.
• An oven function has been selected.
• The light has been turned on at the control panel.
• Oven light may need replacing.
.
TOUBLESHOOTING
41
Advertisement
Table of Contents
Troubleshooting
