Advertisement
Set...
Installing the oven accessories
1. Install telescopic slides (where supplied) to the
side racks. Refer to installation guide supplied
with oven slides.
2. Insert side racks
There is a left hand and right hand version (see image).
1. Insert the rear peg into the rear access hole,
ensuring that the peg is fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
3. To fit a shelf or tray to side racks:
1.
Locate the rear edge of the shelf
in between guide rails of the
side rack. Ensure the same rail
positions on both sides of the
oven are being engaged.
2. With the front edge raised, slide
the shelf into the oven.
3. Once the detents have passed the
front edge of the side rack, the
shelf can be pushed completely in.
Detent
Set the time
You must set the time before you can operate
your appliance.
1. After the appliance has been electrically
connected, '12:00' will be displayed and the
clock icon will flash
2. Press + and - symbols to set the time of day
3. 5 seconds after the last change, the clock
icon will disappear, confirming the time has
been adjusted.
NOTE: The clock has a 24 hour display.
front peg
4. Fit shelf/tray (where
supplied) to telescopic slides
1. Push the shelf or tray along
the top of the slide until it hits
the back post.
Back post
Shelf
Condition the oven
New appliances can have oil or residue left
from manufacturing. You will need to heat
your oven for 30 minutes before using it for
the first time.
1. Turn the function selector dial to FAN
2. Using the temperature selector, set the
Left hand side rack
rear peg
2. Drop the front of the shelf or
tray onto the slide ensuring it
sits behind the front post of the
slide.
3. When fully inserted the shelf/
tray should not interfere with the
closed
oven door.
(to burn off any residue)
FORCED.
oven at 180°C for approximately 30
minutes. Please ensure that the room is well
ventilated during this process.
Front post
Shelf
Advertisement
