Operation; Maintenance; Storage; Safety Switch - Craftsman 29281 Operator's Manual

OPERATION
Become familiar with all of the controls and adjustments
on the Power Rake before operating. Controls for
operating Power Rake are as follows:
SAFETY SWITCH - Must be pressed in before handle
switch can be used to start motor.
HANDLE SWITCH - Pull and hold to start and keep
motor running. When let go motor will stop and safety
switch should re-engage.
POWER CORD - Supplies electricity to the Power Rake,
make sure to connect to a power supply using only
outdoor rated extension cables.
CORD HOLDER - Holds extension cord to help keep it
out of the way and take stress off of the handle switch
cord.
EXTENSION CORD RATINGS
(Use only outdoor rated extension cords plugged into a
ground fault receptacle.)
GAUGE LENGTH
16 Gauge 0 - 50 Feet
14 Gauge 51 - 100 Feet
/_OWER
ORD
CORD
HOLDER
SAFETY
SWITCH
HANDLE
SWITCH
CORD
HOLDER
EXTENSION
CORD
FIGURE 7
MAINTENANCE
CAUTION: BEFORE PERFORMING
ANY MAINTENANCE, MAKE SURE
THE POWER RAKE IS TURNED OFF
AND UNPLUGGED FROM ANY POWER
SOURCE.
• Clean Power Rake and bag before storing. Do not
clean with water, solvents or petroleum based
products.
• Store in a dry place that is not exposed to the
elements and out of the reach of children.
Clear excess debris left in Power Rake housing after
each use.
Make sure nothing has wrapped around the tines/
tine shaft. Remove anything that has wrapped itself
around the tines/tine shaft.
Check and make sure all wing knobs and carriage
bolts are tightened. Re-tighten any loose knobs and
bolts.
6 Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE