Advertisement
VOLKSWAGEN
fig.1
fig.2
fig.3
fig.4
fig.5
EasyGlide
The EasyGlide
not in use it can either be stored vertically at the rear
of the vehicle or fold flat into the floor to allow easier
access to the rear storage space.
Transfer from flat to vertical position
A.
From the flat position, pull the lever
side of the ramp to release the ramp.
B.
Using the handle in the centre of the ramp
the ramp up and towards the rear of the vehicle.
C.
Walk the ramp back until the bottom latches engage.
The ramp is now secured in the vertical position
Deploying the ramp
D.
From the vertical position, pull the lever
left side of the ramp to release the ramp.
E.
Using the handle in the centre of the ramp
the ramp out towards you. The ramp will lower as you
draw it out.
F.
Once fully lowered, the ramp is ready to use
IMPORTANT NOTE
Please ensure the ramp is fully extended and rests on a
stable and level surface when in use. Pay careful
attention when boarding and alighting via the ramp if
your vehicle is parked on a slope or a steeply cambered
road, particularly when facing uphill as this increases the
angle of the ramp. While the ramp surface is
slip-resistant, extra care should be taken when operating
in wet conditions.
When parking, leave enough room at the rear of the
vehicle for wheelchair entrance and exit (approx. 3
meters to the nearest obstacle).
Freephone 0800 587 9656
www.alliedmobility.com
TM
Ramp Operation - Deploy
ramp is a double action ramp. When
TM
page 3
USER GUIDE
on the right
fig.1
, lift
fig.2
.
fig.3
on the
fig.4
, pull
fig.2
.
fig.5
Advertisement
