Dell EqualLogic PS5000 Hardware Maintenance page 29

Storage arrays

Hide thumbs Also See for EqualLogic PS5000:

Table of Contents

PS5000 Hardware Maintenance

•

Disconnect any serial or network cables attached to the control module. If you

have a dual control module array, you may want to re-attach the network

cables to the functioning control module to ensure uninterrupted data access.

To remove a control module, follow the instructions in Figure 3-5.

Note: If you are removing a failed control module, you must remove the compact

flash card from the failed control module, as described in Replacing the

Compact Flash Card on page 3-12. Then, install the card in the

replacement control module. This will ensure that the new control module

is running the correct firmware.

Figure 3-5: Removing a Control Module

Maintaining Control Modules

3–9

Table of Contents

Equallogic ps series