Burrow OPERA Assembly Instructions page 3

5
Repeat the same process for the left side
panel, and make sure all three panels are
flush with back edge of top panel.
7
Take the bottom panel, flip it upside-down,
and fit the tabs on the side panels and
partition into the slots on the bottom panel.
Firmly push the bottom panel backward,
toward the back panels, to lock it in place.
4
6
Slide the back panels, pin-edge first, into
the grooves on the side panels and interior
partition. Fit the pins into the holes on the
top panel.
8
Gather the wood screws and use the ratchet
screwdriver to insert them into all of the pre-
drilled holes on the bottom panel.
9
Grab all five legs and twist them into the
inserts on the bottom panel. The center
leg is slightly thinner and shorter, and
offers additional support once you've
Tip: Twist the foot of the leg to adjust
height and compensate for uneven floors.
10
With a partner, flip the media console upright.
loaded up the console. The corner legs, as
you can probably guess, go in each of the
four corners.
11
Take the shelves, slide them inside either
half of the unit, and lower the notches over
the pins.
5