Table of Contents
Advertisement
Read Before Operation
Preparation Before Operation
2
Position
–
correctly!
3
1
Remote controller
Screws
Remote
controller holder
NOTE
„ Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both batteries at the same time.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance
occurs within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
„ Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with a soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the
shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance somewhere else, or consult your dealer.
„ Celsius/Fahrenheit display change function of remote controller
• The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
• Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C.
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of
the original set temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no
temperature change.
• A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display
change function.
9
„ To set the batteries
+
and
1.
Slide the front cover to take it off.
2.
Set two dry batteries AAA.LR03 (alkaline).
3.
Set the front cover as before.
„ To fix the remote controller holder to a wall
1.
Choose a place from where the signals
reach the unit.
2.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3.
Place the remote controller in the remote
controller holder.
„ Celsius/Fahrenheit display switch
• The Celsius or Fahrenheit display is selectable with the following buttons.
Press
5 seconds.
• The temperature will be displayed in Fahrenheit if it is presently displayed in
Celsius, and vice versa.
and
simultaneously for
Advertisement
Table of Contents
