Page 4
The R Series Positioning System for Powered Wheelchair is designed for use with power wheelchairs. The R Series Positioning System for Powered Wheel- chair use the Merits Model P323/P324 Power Wheelchair as the base unit for the tilting, reclining and elevating System. The Positioning...
Page 5
System and base unit is to be sold together. Model P323/P324 Powered Wheelchair is bat- tery powered, center wheel motor driven and is controlled by the PG power wheelchair controller. The user interface is a joystick. P323/P324 is powered by two 12 VDC 62ah batteries.
Page 6
Refer to Controller System Operation manual Battery Gauge On / Off Horn Speed Meter Decrease Speed Increase Speed Actuator Actuator Joystick R-NET LED R-NET LCD...
SAFETY WARNING YOUR AUTHORIZED DEALER, PROVIDER, THERAPIST(S), AND/OR OTHER HEALTHCARE PROFESSIONALS ARE RESPONSIBLE FOR DETERMINING YOUR REQUIREMENT FOR A SEAT BELT FOR SAFE OPERATION OF YOUR MOBILITY DEVICE. REQUIRING A SEAT BELT TO SAFELY OPERATE YOUR MOBILITY PRODUCT, MAKE SURE IT IS FASTENED SECURELY IN ORDER TO REDUCE THE POSSIBILITY OF A FALL FROM THE MOBILITY PRODUCT.
Page 9
Warnings DO NOT use an escalator to move a wheelchair between floors. Serious bodily injury may occur. DO NOT lean over the top of the back upholstery to reach objects from behind as this may cause the wheelchair to tip over. DO NOT shift your weight or sitting position toward the direction you are reaching as the wheelchair may tip over backwards or sideways.
Page 11
Warning: The wheelchair might disturb the operation of devices in its environment that emit electromagnetic fields (e.g. alarm systems of shops, automatic doors)
Page 14
(Refer to specification on page 15.) (Refer to specification on page 15.)
Page 16
P323 R-Series Positioning Headrest Seating System R-Series Positioning Seating System Joystick Armrest Seat Shroud Rear Caster Power Drive Wheel Base Footrest Front Caster Manual Freewheel Lever...
Type B applied parts: seat, armrest, foot plate, joystick module. Classification: Internal powered equipment by 24 VDC, Class II in charging mode. Mains connection of battery charger: 100-120 VAC, 50/60 Hz. Braking information: 1) Running brake: Your electrical wheelchair is equipped with electromagnetic and regenerative brakes.
Page 19
Fig A3 Fig A4 (4) Take apart the Velcro (top). (3) Take apart the velcro (rear). (Fig A4) (Fig A3) Fig A5 Fig A6 (6) Fasten the Velcro on the right (5) Fasten the Velcro on the left shroud. (Fig A6) shroud.
CARE AND MAINTENANCE Your powerbase wheelchair requires a minimal amount of care and maintenance. If you do not feel confident in your ability to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized. The following areas require periodic inspection and/or care and maintenance.
Page 24
Cleaning and disinfection Battery terminal connections ABS plastic shrouds Motor brushes 38 22...
DAILY CHECKS WEEKLY CHECKS Note: The powerbase wheelchair may move when performing this test. Immediately release the joystick. You must be able to hear each electrical brake operating within a few seconds of joystick movement.
Page 27
Wheel replacement If your powerbase wheelchair is equipped with pneumatic tires and you have a flat tire, you can have the tube replaced. If your powerbase wheelchair is equipped with a solid tire insert, either the solid insert or the entire wheel must be replaced depending on the model. Contact your dealer for information regarding replacement wheels for your powerbase wheelchair.
Page 32
IEC Symbols Direct current Protect against splashing water IPX4 Attention, consult accompanying document. ON/ OFF Button on the controller 5A/24V Use DC24V/5A charger Follow the instructions for use Type B applied part Class II Equipment...
Need help?
Do you have a question about the P324 and is the answer not in the manual?
Questions and answers