Using Remote / Power Button - Kogan UN8920 User Manual

USING REMOTE CONTROL / POWER BUTTON
4. Turning TV on
a. Plug the power cord into a suitable power outlet. The standby will display
a red light, showing that the TV is receiving power.
b. Press the POWER ( ) button (either on your remote control or beneath
the front panel on the TV) to turn the TV on.
c. The standby light will turn to green when the TV is on.
TURNING TV OFF
POWER ( )
Press the button on the remote control to enter
standby mode.
To power down the TV completely, unplug the power cord from
the power outlet.
Do not leave your set in standby mode for long periods of time. If you
will not use the TV for a long time, it is recommended to unplug the
set from both the power outlet and aerial.
5. Pairing the Magic Remote
remote toward the TV and then long-press the wheel. The
remote control will automatically be registered. A notification
will confirm, and the pointer will appear on screen.
If the Magic Remote's pointer does not appear on the screen,
Red light on
you must re-register it. Point the remote control towards the
TV and long-press the GUIDE button until the notification
appears.
4a
Standby mode
6. Using remote control without bluetooth
the Magic Remote has bluetooth capability, but until
this is paired with your TV, you will need to ensure
4c the distance between the remote control and the TV
is no greater than 8 metres, at an angle of no more
that 30 degrees on either side (6a). Point the remote
TV on
towards the sensor at the front of the TV (this may
4b
TIPS
Do not block the path between the sensor and the remote control.
WARNINGS
• One loading of batteries will last for 1 year under normal use.
• If you do not intend to use the remote controller for a long period of time,
remove them to avoid damage due to leakage.
• Do not use old and new batteries together.
• The batteries (battery pack or batteries installed) shall not exposed to
excessive heat such as sunshine, fire or the like.
wheel
GUIDE
button
6a
9