Table of Contents
Advertisement
>>DHCPv6
? Off
>>NetBEUI
? On
7-46
DHCPv6 (DHCPv6 setting)
DHCPv6 is the next-generation of the Internet's Dynamic Host
Configuration Protocol and supports IPv6. It extends the BOOTP startup
protocol that defines the protocols used for transferring configuration
information to hosts on the network.
DHCPv6 permits the DHCP server to use its expanded functionality to
send configuration parameters to an IPv6 node. Because the network
addresses that can be used are allocated automatically, the IPv6 node
management workload is reduced in systems where the administrator
has to exercise close control over IP address allocation.
1
Press while >TCP/IP (IPv6)
2
Press or repeatedly until >>DHCPv6 appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Protocol Detail (Detailed settings for the network
protocol)
This selects the settings for Protocol Detail.
The options available in the Protocol Detail settings are as follows:
• NetBEUI (NetBEUI setting)
• SNMPv3 (SNMPv3 setting)
• FTP (Server) (FTP (Server) setting)
• SNMP (SNMP setting)
• SMTP (SMTP setting)
• POP3 (POP3 setting)
• RAW Port (RAW Port setting)
• LPD (LPD setting)
• HTTP (HTTP setting)
1
Press while Network > is displayed.
2
Press or repeatedly until >Protocol Detail > appears.
NetBEUI (NetBEUI setting)
Selects whether or not to receive documents using NetBEUI.
1
Press while >Protocol Detail > is displayed.
2
Press or repeatedly until >>NetBEUI appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using or .
5
Press [OK].
On > is displayed.
Using the Operation Panel
Advertisement
Table of Contents
