Note
Turbo Timer must be turned on by an authorized Directed
dealer.
Note
For Turbo Timer mode on manual transmission vehicles fol-
low the directions in the Manual Transmission Start (MTS
mode) section with the door open and in step 3 send the
Timer Mode command from the remote control.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. A Remote Start Fault may be caused by any of sev-
eral configuration issues. If the remote start fails to activate, refer to the
table below for the command type and parking light flashes that will
identify the configuration issue and solution.
Flashes *
Possible Fault
5
Brake on
6
Hood open
7
After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
8
Toggle Switch off
* Refers to the number of parking light flashes.
20
Solution
Release foot brake
Close hood
Enable MTS mode
Check all Solutions
Turn switch on
© 2016 Directed. All rights reserved.
Need help?
Do you have a question about the 44606P and is the answer not in the manual?
Questions and answers