Table of Contents
Advertisement
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
tool changing
Bit installation
cautiOn! tO preVent inJury: Wear heavy‑duty
work gloves to provide protection when inserting and
removing drill bits. Drill bits become very hot during
use. Do not remove drill bits until the bit has cooled.
1. Rotate Chuck's Collar counterclockwise
to open or clockwise to close Jaws, so
that Jaws are slightly larger than bit.
2. Use a drill bit (sold separately) designed for the
workpiece type. Insert bit into center of Jaws.
note: For hex shank or three‑sided shank
bits, align flat sides of bit with Jaws.
Workpiece and Work area Set up
1. Designate a work area that is clean and well‑lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
General instructions for use
1. Make sure that the Trigger is in the
off‑position, then plug in the tool.
2. Slide Direction Switch to the right side
for clockwise rotation. Slide to the left
side for counterclockwise rotation.
cautiOn! tO preVent inJury: Do not change
direction while the drill is operating. Allow chuck to come
to complete stop before changing direction of rotation.
cautiOn! tO preVent inJury: Most
drill bits are designed for use in the forward,
clockwise direction. Do not use a drill bit in the
opposite direction than it is designed for.
Page 8
For technical questions, please call 1-888-866-5797.
3. Lift bit slightly from bottom of chuck. Hand
tighten Collar clockwise until bit is held securely
in place and centered between Jaws.
4. Insert Chuck Key into one hole on side of Chuck
so that teeth on Key engages gear on Chuck.
Tighten securely. Repeat on other holes.
5. Remove bit by inserting Chuck Key into one hole on
side of Chuck so that teeth on Key engages gear on
Chuck. Turn Key counterclockwise and remove bit.
nOtice: use sharp bits. Dull, bent, or damaged
bits will cause stress on the drill and/or break.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
3. Hold the tool properly using both hands.
4. Squeeze Trigger to start tool. The Trigger
has a variable speed. Pressing it lightly
will make tool operate slowly; pressing
more will cause tool to operate faster.
WarninG! tO preVent SeriOuS inJury:
The tool will restart automatically if stalled.
5. To prevent accidents, turn off the tool and
disconnect from power source after use. Clean,
then store the tool indoors out of children's reach.
Item 56179
Advertisement
Table of Contents
