Table of Contents
Advertisement
Problem
The appliance is activated and does
not heat up. The fan does not oper‐
ate. The display shows "Demo".
The appliance is activated and does
not heat up. The fan does not oper‐
ate. The display shows "Demo".
13.2 Service data
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the oven cavity. Do not remove the rating plate from the oven cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
14. ENERGY EFFICIENCY
14.1 Energy saving
The oven has features which help you
save energy during everyday cooking.
Make sure that the oven door is closed when
the oven operates. Do not open the oven
door too often during cooking. Keep the door
gasket clean and make sure it is well fixed in
its position.
Use metal cookware to improve energy
saving (only when you use a non-microwave
function).
When possible, do not preheat the oven
before cooking.
Keep breaks between baking as short as
possible when you prepare a few dishes at
one time.
34
ENGLISH
Possible cause
The demo mode is activated.
The demo mode is activated.
.........................................
.........................................
.........................................
Cooking with fan
When possible, use the cooking functions
with fan to save energy.
Residual heat
If a programme with the Duration or End Time
selection is activated and the cooking time is
longer than 30 min, the heating elements
automatically turn off earlier in some oven
functions.
The fan and lamp continue to operate. When
you turn off the oven, the display shows the
residual heat. You can use that heat to keep
the food warm.
When the cooking duration is longer than 30
min, reduce the oven temperature to
minimum 3 - 10 min before the end of
cooking. The residual heat inside the oven
will continue to cook.
Remedy
1.
Deactivate the appliance.
2.
Touch and hold
pliance activates and deacti‐
vates.
3.
Touch and hold
the same time until an acoustic
signal sounds. "Demo" goes
out.
Refer to "Daily Use chapter, Basic
Settings.
until the ap‐
and
at
Advertisement
Table of Contents
