Locating Your Electric Fireplace - Comfort Glow ES4195 Installation Instructions And Homeowner's Manual

LOCATING YOUR ELECTRIC FIREPLACE

Your new freestanding electric fireplace may be installed virtually anywhere indoors in your home. However,
when choosing a location for your new electric fireplace, ensure that the general instructions and warnings
from pages 3 and 4 are followed. For best results, install the electric fireplace out of direct sunlight.
 If you are placing the heater in an alcove, make sure that there is at least 6 inches of space on all sides
to ensure good air circulation.
 The fireplace heater must not be located over a fixed electrical socket. The socket must always be
accessible in order to disconnect the heater from the electrical supply for maintenance.
 Use your heater only in dry environments. This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate the heater where it may fall into a bathtub or other water
container. Do not use your heater outdoors. Do not use near sinks, swimming pools or other damp areas
such as flooded basements, garages, etc or anyplace where the heater could come in contact with water.
CONTROLS
Location of Controls
. The MAIN POWER switch is located on the upper right-hand side of heater (See product diagram on Page 2).
1
2. Thermostat control wheel - Adjust to maintain desired room temperature.
3. ON/OFF switch for main power, and simulated flame. (No Heat)
4. Heat switch – One switch for low heat setting (750 Watts)
5. Heat Switch - Two switches for high heat setting (1500 Watts)
2. Adjustable Thermostat
3. Main Power & Flame Effect (no heat)
4. Heat Switch I = Low heat 750W
5. Heat Switch II = High heat 1500W
~ 6 ~