Valcom VIP-160 Installation Instructions

INTRODUCTION
The VIP-160 Talkback IP Ceiling Speaker enables
handsfree talkback access to a single location over
an IP-based LAN/WAN. This allows handsfree
communication anywhere on the network. The
VIP-160 levels are adjusted electrically via software
during setup. A call switch input is provided for call
in initiation. Power is provided to the VIP-160 via a
Power over Ethernet (PoE) switch meeting the
802.3af specification.
SPECIFICATIONS
Access Methods
PBX, FXO Port w/VIP-811
POTS telephone set w/VIP-811
PBX, FXS Port w/VIP-821
Valcom M Cast Page Group
SIP – enabled telephone system
Features
RJ-45 network connection
802.3af compliant
High Efficiency Class-D Amplifier
INSTALLATION
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case the
user will be required to correct the interference at
his own expense.
Packing List
Qty.
1
1
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
TALKBACK IP CEILING SPEAKER
Item
VIP-160
VSP Document
VIP-160
DIMENSIONS/WEIGHT
13.00" Dia x 3.00" D
(33.02cm Dia. x 7.62cm D)
Weight: 2.5 lbs (1.13 kg)
Environment
Temperature:
Humidity:
Precautionary Designations
CAUTION: To reduce the risk of electric shock,
No user serviceable parts inside.
Refer servicing to qualified service personnel.
Network Connection
The VIP-160 has one CAT-5 RJ-45 network
connector on the rear panel. Connect the VIP-160
to an Ethernet switch. (See Figure 1).
Call Switch Connection
The Talkback IP Speaker provides a call switch
input via screw terminal connections. See
Figure 1 for detailed connections.
1
Issue 1
Issue 1
0 to +40° C
0 to 85% non-precipitating
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Do not remove cover.
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
947792