Table of Contents
Advertisement
en Basic operation
8.4 Interrupting the operation
You can interrupt the operation and then continue
again.
1.
To interrupt the operation, press
2.
Press
again to resume operation.
8.5 Setting the operating mode
After you have switched on the appliance, the menu
appears on the display.
1.
To scroll through the various options, press
2.
To select a function, press the corresponding tile.
a Depending on the function, possible adjustment val-
ues or other tiles are available for selection.
3.
If required, press on another tile.
4.
To change the adjustment values:
Press
or
.
‒
Or select the values directly using the adjustment
‒
bar.
5.
Press
to start the operation.
6.
If the operation is ended:
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Note: You can save your settings via the Home Con-
nect and use these again.
8.6 Filling the water tank
The water tank is located next to the cooking compart-
ment. You will need to fill the water tank before starting
any operation that uses steam.
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
▶
When opening the door, do not stand too close to
the appliance.
▶
Open the appliance door carefully.
▶
Keep children at a safe distance.
The water in the evaporator dish is still hot even after
the appliance has been switched off.
▶
Never empty the evaporator dish immediately after
switching off the appliance.
▶
Allow the appliance to cool down before cleaning.
When you open the appliance door, hot water may flow
out of the appliance.
▶
When opening the door, do not stand too close to
the appliance.
▶
Open the appliance door carefully.
▶
Keep children away from the appliance.
▶
If the evaporator dish overflows, do not pour more
water into the water tank.
ATTENTION!
Using unsuitable liquids may damage the appliance.
▶
Do not use highly chlorinated tap water (>40 mg/l)
or other liquids.
▶
Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
Requirement: The water hardness range is set cor-
rectly.
1.
Open the appliance door.
10
.
or .
to switch the ap-
2.
Remove the water tank from the tank recess.
3.
Open the tank cover.
4.
Fill the water tank with cold water up to the max.
mark.
5.
Close the tank lid.
6.
Insert the full water tank back into the tank recess.
7.
Check that the water tank is flush with the water
tank recess.
8.
Close the appliance door.
Advertisement
Table of Contents
