Steps
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4) tighten the four captive screws that secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
I/O board
Removing the I/O board
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
51