Steps
1. Lift the latch and disconnect the touchpad cable from the system board.
2. Lift the latch and disconnect the touchpad cable from the touchpad.
3. Lift the touchpad cable off the palm-rest and keyboard assembly.
4. Remove the five screws (M1.6x2.5) and the four screws (M2x2) that secure the touchpad to the palm-rest and keyboard
assembly.
5. Lift the touchpad off the palm-rest and keyboard assembly.
Installing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the touchpad and provides a visual representation of the installation procedure.
58
Removing and installing Field Replaceable Units (FRUs)