Hotpoint HUE 52G Instructions For Installation And Use Manual page 19

Care and Cleaning
Cleaning the glass door with 3 panels*
TOP OVEN DOORS
SIDE OPENING MAIN OVEN DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the
weight of the inner glass when removing and
refitting.
! For the safety of the glass when glass-refitting the
side-opening door should be fully open
The glass panel may now be washed at the sink.
Stubborn stains can be removed by using a fine
steel wool soap pad.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Removing the retaining Removing the retaining
bar: 1.Depress carefully bar:
the clips on
both sides of the bar.
2.Pull the trim up gently
until the retainer is
released.
Open the door fully and
carefully slide the first
inner glass towards you,
taking care not to allow the
glass to fall.
Repeat the same
procedure with the next
glass.
Now the external glass
panel can be washed.
1.Depress carefully the clip
on one side of the bar.
2.Pull the trim up gently
until the retainer is
released
Open the door fully and
carefully slide the first
inner glass towards you.
Repeat the action with the
second glass.
Ensure the glass panel is not subjected to Ensure the glass panel is not subjected to
Ensure the glass panel is not subjected to Ensure the glass panel is not subjected to Ensure the glass panel is not subjected to
any sharp mechanical blows. Take particular any sharp mechanical blows. any sharp mechanical blows. any sharp mechanical blows. any sharp mechanical blows.
care not to damage the inner surface which is coated
with a heat reflective layer. After cleaning, rinse and
dry with a soft cloth. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
Glass door refitting
To reassemble the oven doors proceed with inserting
the glass panels in the reverse order, pushing gently
every panel directly into the liners.
Push the panel until it does not protrude beyond the
edge of the door
BE CAREFUL NOT TO DAMAGE THE GLASS
WHEN REMOVING/ REASSEMBLING THE
PANELS.
When refitting the glass make sure the glass and
the protecting bars are fitted correctly.
* Models: HUE 52; HUE 53
Make sure the
protecting bars are
fitted correctly.
19
GB