Table of Contents
Advertisement
Turning on the Appliance
Starting a cycle wash
1 Draw out the lower and upper basket, Draw out the lower and upper basket.
It is commended that loading the lower basket first, than the upper one (see
the section entitled " Loading the Dishwasher ").
2 Pour in the detergent (see the section entitled " Salt, Detergent and Rinse Aid ").
3 Insert the plug into the socket. The power supply is 220~240 VAC / 50 Hz, the
specification of the socket is 10 A, 250 VAC. Make sure that the water suppl y is
turned on to full pressure.
4 press the On / Off button, and the On / Off i ndicator on. Press the Program
buttons to select a desired wash cycl e. Close the door, After 10 seconds, the
machine will work.
Premise:
1. A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2. Open the door, press the desired program button and hold more than 3 seconds, until the
desired program indicator is on (see the section entitled " Starting a wash cycle ... ").
NOTE:
If you open the door when washing, the machine will pause. When you
close the door , the machine will keep on working after 10 seconds.
The Program indicators show the state of the dishwasher:
a) All program indi cators are off, -------------------> Stand by
b) One of the program indicators is on,---------------> Pause
c) One of the program indicators is bl inking,-----------> Run
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working, you can open the door
completely.
It is dangerous to open the door when washing,because the hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
14
Advertisement
Table of Contents
