Henny Penny HHC-983 Operator's Manual page 19

4-4. SPECIAL PROGRAMMING
(Continued)
SP-3 Air Temperature Setpoint
SP-4 Humidity Setpoint
SP-5 Out of Water Trip Point
SP-6 Clean Water Pan Setpoint
SP-7 System Initialization
(Factory Settings)
402
9. Press and "SP-3, AIRTEMP SETPOINT," and the
preset cabinet temperature shows in display.
10. Press
o o
140 F (60 C) minimum, 210
11. Press and "SP-4, HUMIDITY SETPOINT," and the
preset humidity setpoint shows in display.
12. Press to change the humidity setpoint, 0 to 90%.
13. Press and "SP-7, OUT OF WATER TRIP POINT" and
the preset trip point temperature shows in display. If the float
switch fails, the trip point temperature is the water pan tempera-
ture at which the control senses the water pan is out of water.
We recommend a trip point temperature of 450
14. Press to change the out-of-water trip point.
15. Press and "SP-8, CLEAN WATER PAN SETPOINT,"
and the preset temperature, at which the controls senses that
the water pan needs cleaned of lime, shows in the display.
We recommend a setpoint temperature of 425
16. Press to change the setpoint.
17. Press and "SP-9, DO SYSTEM INIT" shows in display.
18. Press and hold
the display flashes "-INIT-," then "INIT*DONE." This com-
pletes the initialization, and sets the control to factory settings.
Model HHC-980/983
to change the air temperature setpoint,
o o
F (99 C) maximum.
until the display counts down from 3, and
o o
F (232 C).
o o
F (218 C).
4-4