Table of Contents
Advertisement
Appliance settings
en
Removing laundry/switching
off the appliance
Press the # button till the indicator
1.
lamp turns off, release the button.
The appliance is switched off.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
40
Q
Appliance settings
A utomatic switch-off
A p p l i a n c e s e t t i n g s
If the appliance is not operated for a
prolonged period (at least 20 minutes,
depending on the water level inside of
appliance), it will automatically switch
off before the programme starts or after
the programme has ended. Press the
power button # again to switch on the
appliance.
Basic settings
To access the basic settings, touch and
hold the ç (Silent) button for approx. 3
seconds. The control panel show:
You can change the following basic
settings:
The volume of the end signal.
■
The volume of the buttons.
■
The brightness of the Touch-Display.
■
Switching the Tambur bakım (Drum
■
Clean) information signal on/off.
Advertisement
Table of Contents
