Starting An Edit - Sony BETACAM SX A220P Operation Manual

Monitoring signals during an
edit
Just as during a preview, you can see
the video in the recorder side LCD
monitor and listen to the audio
through the recorder side speaker.
The figure below shows the video and
audio signals which can be monitored.
IN point
Recorder
Player
playback
E-E signals
signals
Note
To perform insert editing, CTL must
be recorded in advance on the recorder
side tape. You cannot perform editing
on the sections of the tape where CTL
have not been recorded. If a section
with no CTL is encountered, the E-E
picture for that section is replaced by
noise on the monitor.

3-4-2 Starting an Edit

To start an edit, press the AUTO
EDIT button.
OUT point
Recorder
playback
signals
AUDIO IN
– +
TRIM
GOOD
LIST MARK
SHOT
DELETE ENTRY SHIFT
IN OUT
PREVIEW REVIEW
AUTO EDIT
REVIEW button
AUTO EDIT button
The AUTO EDIT button is lit during
an edit. It goes out when the edit
finishes.
To stop an edit
Press the ENTRY/SHIFT button
together with the OUT button.
The edit ends, and the point where you
pressed the buttons becomes the OUT
point.
To abort an edit
Press the STOP button on the
recorder.
To review the edit results
Press the REVIEW button. When the
review ends, the tape returns to the
OUT point and stops.
ENTRY/SHIFT
button
OUT button
3-11
Editing