Table of Contents
Advertisement
2-1 Power Preparations
This unit can be powered by batteries
or AC power.
Note
If you attach or remove batteries or
AC adaptors incorrectly, they may fall
down and cause body injury. Follow
the procedures described below to
attach or remove them.
2-1-1 Usable Batteries
Batteries that can be used with this
unit are as follows. For each type of
battery, a special battery adaptor and
battery charger is required.
Battery
Battery
Adaptor
BP-90(A)
DC-L90
(mounted on
this unit)
BP-90(A)
DC-210
(connected
to DC IN
connector)
BP-L60(A)/
Not
L90(A)
needed
Notes about battery usage
• Before using the batteries, be sure to
charge them fully with the special
battery charger. Refer to the
operating instructions of your battery
charger for more information about
how to charge the batteries.
• Batteries may not be completely
charged if you charge them
immediately after use when they are
still warm. You should wait until the
batteries cool before charging them.
Battery
Charger
BC-210/210CE/
410/410CE
BC-210/210CE/
410/410CE
BC-L100/
L100CE/L50
2-1-2 Using the BP-
L60(A)/L90(A) Battery
Pack
This unit can be operated for about 90
minutes at normal temperature on two
fully charged BP-L90 Battery Packs.
To charge the battery pack
Before use, charge the battery pack
with the BC-L100/L100CE Battery
Charger. It takes about 2.5 hours to
charge the BP-L60(A) and about 3.5
hours to charge the BP-L90(A).
For more information about how to
charge the battery pack, refer to the
manual for the BC-L100/L100CE.
To attach the battery pack
Attach the BP-L60(A)/L90(A) as
shown in the figure on next page.
Before attaching, remove the cover of
the battery connector.
Remove the cover in the same way that
you remove the battery pack. For
details see the next section "To
remove the battery pack".
2-1
Preparations
Advertisement
Table of Contents
