Installation; Installation Preparations - Gaggenau AI 400720 Operating And Installation Instructions

Installation

The extractor hood is designed for installation on
the kitchen ceiling or on a rigid suspended ceiling.
•
During installation, optional accessories may
also require fitting.
•
Observe the minimum distance between hob
and extractor hood (see "Safety instructions")!
•
Avoid damaging the sensitive surfaces!
Preparing the ceiling
RISK OF INJURY,
DAMAGE TO PROPERTY
Before drilling the holes for the designated
installation location, check for concealed electrical
cables and other lines.
•
The ceiling must be level and horizontal.
•
The enclosed screws and wall plugs are
suitable for concrete and natural stone. Use the
appropriate fasteners for other ceiling
structures.
Ensure that the ceiling has adequate load
bearing capacity.
•
Ensure that the depth of the drilled holes
corresponds with the length of the screws.
•
Ensure that the wall plugs are secure.
Max. weight: 110 lbs.
Design subject to modification in line with technical
development.
Note: At least one screw for the mounting must be
installed through a stud.
Note:
the extractor hood is to be installed to a kitchen
ceiling or suspended ceiling. Ensure that the ceiling
is capable of providing a firm hold for a maximum
weight of hood and accessories of 50 kg / 110 lbs.
Before marking the securing holes, make sure that
no electricity wires or water pipes or other wires/
pipes are laid at the drilling points in the ceiling.
Before installation check the enclosed wall plugs
and screws are suitable for your ceiling. If
necessary use special wall plugs.
Installation of the extractor hood:
1 Using the drilling template mark the position of
the screws on the ceiling.
7
7 / ''
8
5
2 Drill 4 holes Ø / " for the wall plugs. Push the
16
plugs flush with the ceiling.
3 Turn two screws to a
placed in a position, in which at a later stage of
the installation the key-holes of the supporting
frame are found (namely back left and front
right from the control panel of the hood).
5
13 / ''
8
3
/ " gap. Both screws are
8
17