Cordless Telephone Operation; Preparing For Use; Receiving Calls - Newcont NTP 6304 Owner's Manual

Getting Started
HANDSET
NEW CALL
MSG WAITING
L D C C F CALLS BATT MSG DIR
AM MIN SEC RPT
PM NEW TOTAL
13. Set the date and time.(See page 22 for details.)
You are now ready to use your new
NEWCONT Cordless Telephone
IMPORTANT
In order to utilize the Caller ID feature, you
must subscribe to Caller ID service from
your local telephone company.
Press the button to confirm that
you have a dial tone. If you do not get a
dial tone, review steps 3 through 12. If
you still do not have a dial tone, refer to
the Problem Solving section on page 30.
BELT CLIP HOOK
With the back of the HANDSET facing up, insert
one side of the BELT CLIP HOOK into the
matching slot at the top side of the HANDSET.
Press down on the opposite side of the BELT
CLIP until the other hook locks Into the slot on
the side of the HANDSET.
7

Cordless Telephone Operation

Preparing for Use

Before you can use cordless telephone ,you must charge the HANDSET for 12
hours. Failure to do so will require recharging of the BATTERY PACK more often.
1. Place the HANDSET on the BASE UNIT for 12 hours .
2. After 12 hours ,remove the HANDSET from the BASE UNIT.
3. Raise or reposition the BASE UNIT ANTENNA for the best reception.
Before you can use your cordless telephone, you must charge the HANDSET
for 12 hours. Failure to do so will require more frequent charging of the
BATTERY PACK. See page 28 for more information on the BATTERY PACK.
NOTE:
Depending on the frequency of use, once the HANDSET is fully charged , it remains
functional for approximately 4 hours of continuous use and approximately two days
when the HANDSET is off the BASE UNIT in STANDBY mode.

Receiving calls

1. When the phone rings, lift the HANDSET and
press the button. The HANDSET LCD
Screen will display "CALLS" and "TALKING",
and the BASE UNIT IN USE LED indicator will
light up.
2. Start your conversation
3. To end your conversation, either press the
button or place the HANDSET on the
BASE UNIT. If you place the HANDSET on the
BASE UNIT CHARGE CRADLE, you activate
the automatic STANDBY feature.
NOTES:
1. The Call Timer will start to count once you press the
2. The LCD Screen emits light for 8 seconds every time you press any of the
TELEPHONE KEYPAD buttons.
CALLS
Call Timer Display
CALLS
button.
When "CALLS"appears on the LCD Screen,
it means the HANDSET IS OFF-HOOK
(connected to the telephone line).
Minutes
Seconds or Channel (Press the scan/del
button to display the channel).
8