Getting Started - Newcont NTP 6304 Owner's Manual

Getting Started

Connecting Your Phone
This section is a reference guide to the basic functions and operations of your cordless
telephone. For more detailed descriptions of the operations and features of this telephone,
refer to the Contents on page 1.
1. Carefully remove your cordless telephone from its shipping carton. If there is any
visible damage, do not attempt to operate this equipment. Return it to the place of
purchase.
2. Check to be sure you have all items that come with this cordless telephone system.
You should have a HANDSET , BASE UNIT, AC ADAPTOR, MOUNTING BRACKET ,
TELEPHONE LINE CORD, SHORT TELEPHONE LINE CORD ,BELT CLIP and
Owner's Manual.
NEW CALL
MSG WAITING
L D C C F CALLS BATT MSG DIR
AM MIN SEC RPT
PM NEW TOTAL
3. Insert the small plug on the end of the AC ADAPTOR into the POWER-IN CONNEC-
TION JACK at the back of the BASE UNIT.
4. Plug the AC ADAPTOR into a 120V AC wall outlet.
USE ONLY WITH CLASS 2 POWER SOURCE 9V DC,300mA
5. Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE JACK
and the other end into the TELEPHONE LINE CONNECTION JACK at the back of the
BASE UNIT. (If you have an older 4-prong TELEPHONE JACK, you will need an
RJ-11C TELEPHONE JACK ADAPTOR. This adaptor is available at the same place
you purchased your telephone.)
6. Raise or reposition the ANTENNA on the BASE UNIT for the best reception.
7. We recommend not placing this unit next to appliances, Doing so may cause
interference.
2.4GHz
IN USE CHARGE
5
Getting Started
BASE UNIT
BASE UNIT
ANTENNA
TONE PULSE
TONE/PULSE
SELECT SWITCH
8. Install the BATTERY PACK by plugging it
into the BATTERY CONNECTOR inside the
BATTERY COMPARTMENT.
9. Place the BATTERY PACK inside the
BATTERY COMPARTMENT.
10.Slide the HANDSET BATTERY COMPART-
MENT COVER firmly into place in its closed
position.
11.IMPORTANT:Before initial use, charge the
HANDSET for 12 hours.
12.TONE/PULSE Select Switch:
A. If your home is equipped with a tone
dialing system, set the TONE/PULSE
select switch to the TONE position.
B. If you have a rotary dialing system, set
TONE/PULSE select switch to the
PULSE position.
C. If you are unsure which system you have,
set the TONE/PULSE select switch to the
TONE position. Press the
on the HANDSET to make a call. If the
call connects, leave the switch as is;
otherwise set to the PULSE position.
TELEPHONE LINE
CONNECTION
JACK
POWER-IN
9VDC 300mA TEL LINE
CONNECTION
JACK
120VWALL
OUTLET
AC ADAPTOR
BATTERY PACK
BATTERY
CONNECTOR
button
BATTERY
COMPARTMENT
COVER
6