Table of Contents
Advertisement
Cordless Telephone Operation
Extension Phones
Extension telephones can be connected. This
telephone can detect when an extension phone
is being used whether the HANDSET is
ON- HOOK or OFF-HOOK. When you lift the
HANDSET and an extension phone is being
used, "EXT IN-USE " will be displayed and
simultaneously the PRIVATE CALL indicator
will blink on the LCD Screen. This means that
an extension telephone is in use. You will have
to wait until the line is free to make a call.
Placing Calls
1. Press the
button, the Call Timer
starts to count. The HANDSET LCD Screen
will display "CALLS " and "TALKING ", and
the BASE UNIT IN USE LED indicator will
light up.
2. Listen for a dial tone.
3. Dial the phone number.
4. when you have finished your call, press the
TALK button again or place the HANDSET
on the BASE UNIT.
NOTE: You can pre-Dial the phone number
before you press the
button. The number
displayed will be dialed once
is pressed.
PRIVATE CALL
lndicator
NEW CALL
MSG WAITING
L D C C F
CALLS
BATT MSG DIR
MIN
SEC RPT
AM
PM
NEW
TOTAL
9
Cordless Telephone Operation
Using the Headset Feature
Your telephone can utilize a headset (not
included) to be connected to your HANDSET
for you to enjoy hands-free communication.
Insert the small plug at the end of the headset
into the HEADSET JACK at the right side of
the
HANDSET. Follow
the
procedures
discussed in "Receiving Calls "and" Placing
Calls" to receive and place a call.
NOTE: When you plug the headset plug into
the HEADSET JACK it automatically
mutes
the MICROPHONE
SPEAKER of the HANDSET. Unplug
the headset to return the HANDSET
to normal use.
Redial Feature
1. If you get a busy tone, press the
or place the HANDSET on the BASE UNIT to
hang up.
2. Later, press the
button again.
3. Listen for a dial tone.
RE/PA
4. Press the
button, this will automatically
SAVE
redial the last telephone number you called.
5. When you have finished with your call, press
the
button again or place the
HANDSET on the BASE UNIT.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits "beep"sounds to warn
you that the Background noise level is too high for proper communication between the
HANDSET and the BASE UNIT. When you hear this sound, you should move closer to
the BASE UNIT to reduce the noise level. Otherwise, the call will automatically cut off.
HEADSET
MICROPHONE
SPEAKER
and
HEADSET
PLUG(2.5mm)
HEADSET JACK
button
10
Advertisement
Table of Contents
