Assembly; Operation - Bosch Intuvia BUI255 Owner's Manual

English – 8
Inserting and Removing the eBike Battery
For inserting and removing the eBike battery in/from
the eBike, please read and observe the operating in-
structions for the eBike battery.
Inserting and removing the on-board
computer
(14)
(4)
(3) On-board computer
Prerequisites
The eBike can only be switched on when the following
requirements are met:
– A sufficiently charged eBike battery is inserted (see
operating instructions for the eBike battery).
– The on-board computer is properly inserted in the
holder (see "Inserting and removing the on-board
computer", page English – 8).
– The speed sensor is connected properly (see drive
unit operating instructions).
Switching the eBike on/off
The following options are available for switching on
the eBike:
– If the on-board computer is already switched on
when you insert it into the holder, the eBike will be
activated automatically.
1 270 U20 XBI | (14.03.2023)

Assembly

(3)
(15)

Operation

(4) Holder for on-board computer
(14) Locking mechanism for on-board computer
(15) Locking screw for on-board computer
To insert the on-board computer (3), slide it into the
holder (4) from the front.
To remove the on-board computer (3), push on the
locking mechanism (14) and slide it forwards out of
the holder (4).
When you park up the eBike, remove the on-
u
board computer.
The on-board computer can be secured in place to
prevent it from being removed from the holder. To do
this, remove the holder (4) from the handlebars. Put
the on-board computer in the holder. Screw the lock-
ing screw (15) (M3 thread, 8 mm long) from below
into the corresponding thread in the holder. Mount
the holder back on the handlebars.
Note: The locking screw is not designed to prevent
theft.
– When the on-board computer and the eBike battery
are inserted, briefly press the on/off button of the
on-board computer.
– With the on-board computer inserted, push the on/
off button on the eBike battery (bicycle manufac-
turer-specific solutions are possible when there is
no access to the eBike battery on/off button; see
the eBike battery operating instructions).
The drive is activated as soon as you start pedaling
(except for in the push assistance function or with the
assistance level OFF). The drive output depends on
the settings of the assistance level.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20/28 mph, the drive switches off the assistance.
The drive is automatically re-activated as soon you
start pedaling again and the speed is below
20/28 mph.
Bosch eBike Systems