Proximity Sensor And Touch Screen; Ambient Light; Assembly; Prior To Installation - Bosch EasyControl CT200 Installation And Operating Instructions Manual

Assembly

▶ EasyControl takes over the time setting of the Bosch server. If there is
no connection to the server, EasyControl can only be put into
operation in manual operation.
▶ All costs for creating an Internet connection and a smart device are to
be borne by the user.
▶ The type of connected heat source determines, which functions can
be used. Consult the EasyControl site to gain an overview of which
functions are available for which heat source.
3.9

Proximity sensor and touch screen

Fig. 2 Proximity sensor and touch screen
[1] Proximity sensor
[2] Touch screen
A proximity sensor [1] detects a presence in front of the touch screen
[2] and lights up. If nothing more is detected for a short period of time,
the touch screen automatically switches off. If the detection lasts for
longer than 5 minutes, the touch screen automatically switches off.
▶ If required, clean the touch screen with a clean, dry cloth.
3.10

Ambient Light

EasyControl not only communicates with you via the app, but also via
Ambient Light. As soon as you send a heating command via the app to
EasyControl, it lights orange for a second when you increase the
temperature, and blue when you lower the temperature. When you leave
your home, a green light for a second indicates that the heating system
has automatically switched to away mode. Red light: Error occurred in
your heating system. If everything is running normally, Ambient Light will
be off.
4 Assembly
4.1

Prior to installation

▶ Prior to installation, check that EasyControl can be combined with
the heat source.
On the EasyControl site there is a list of possible combinations with or
without the operation of EasyControl.
1) See the back of this document for the web address.
2) See the back of this document for the web address.
4
1)
2
1
0010018148-001
2)
Minimum requirements for installation:
▶ 2-wire cable to a heat source, which is suitable for use with
EasyControl.
▶ Broadband internet access via WLAN 802.11 b/g (2.4 GHz) for use
with the app and internet functions.
4.2

Determining the installation location

A reference room is a room (for example the living room), where the
temperature, which is representative of the whole dwelling, is measured,
and where most time is spent.
If weather-compensated control is used, it is not necessary to locate the
controller in the reference room.
▶ Install the controller on an internal wall in the reference room.
Ensure that there is sufficient clearance around the controller.
Fig. 3 Installation location for controller, clearance
Fig. 4 Installation location for controller, condition
4.3

Fitting the wall plate

When replacing a controller with EasyControl, the existing wall plate can
continue to be used ( section 4.5).
This wall plate can be fastened directly to the wall, for example at the
location of the previous controller.
▶ Pull the mains plug of the heat source from the socket.
0010018149-001
0010018150-001
EasyControl – 6720884199 (2020/03)