Advertisement
- "Stand R Swing" seat assembly (w. "Adjustable Height"
STEP 5
Feature)
Important: Please make sure to use the J1A with J3A-N (the plastic is Green
Color). This is CRITICAL to other assembly steps.
Connect Stand R Swing to the chains by inserting J3A through K2 and secure
with J7A, J9A and J6A as shown in Diagram A.
Connect Stand R Swing chains to the top bar by inserting J3A-N through A4 and
securing with J8A and J6A as shown in Diagram B.
If you wish to shorten the chain length, follow Diagram C.
Diagram A
IMPORTANT: The METAL 'washer' (J7A) is needed
NOTE:
1.
Do not over-tighten the nuts and bolts at every step.
2. Do not snap in the cover of plastic cap until you have finished the assembly of
each step and went back to tighten all of the nuts and bolts.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdprecreation.com
J1A
J3A
J7A
A
in the seat assembly.
DO NOT RETURN TO RETAILER YOU PURCHASED AT.
J9A
J6A
J6A
J1A
J3A
K2
J7A
J9A
20
Advertisement
