Advertisement
Quick Links
EEI –811
DINING CHAIR
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Component:
1
Chair Back
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
Hardware:
A
B
C
D
E
F
2
3
3
2
Seat Frame x1
1
Bolt M8x50mm
x 1
Bolt M8x57mm
x 4
Bolt M8x90mm
x 4
Spring Washer M8
x 9
Flat Washer M8
x 9
Allen Wrench
x 1
Front Leg
x2
3
Page 1 of 3
Advertisement
Related Manuals for modway Perdure EEI-811
Summary of Contents for modway Perdure EEI-811
- Page 1 EEI –811 DINING CHAIR Thank you for purchasing the MODWAY DINING CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
- Page 2 EEI –811 DINING CHAIR STEP 1: Please put Chair Back (1) upside down on a carpeted or padded area. Then open the black fabric which is attached by the Velcro from back to front on bottom of the Seat Frame (2), The inside of the Seat Frame(2) will now be visible.
- Page 3 EEI –811 DINING CHAIR STEP 3: Insert 1 piece of Front Leg (3) into the upper hole on the bottom of Chair Back (1) as shown. Attach by 2 pieces of Bolt (B), 2 pieces of Spring Washer (D) and 2 piece of Flat Washer (E) as shown. Repeat the same steps for Front Leg (3).
Need help?
Do you have a question about the Perdure EEI-811 and is the answer not in the manual?
Questions and answers