Handlebar Switches - Yamaha MT-07M 2015 Owner's Manual

Handlebar switches

Left
1
2
3
4
1. Pass switch " "
2. Dimmer switch " / "
3. Turn signal switch " / "
4. Horn switch " "
Right
1. Start/Engine stop switch "
2. Hazard switch " "
EAU1234K
Pass switch "
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
/ / "
Instrument and control functions
EAU12352
"
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
4-13
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to " ", and then slide
the switch toward " ". See page 6-1
for starting instructions prior to starting
the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
The engine trouble warning light and
ABS warning light (ABS model only)
may come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU68270
/ "
4
EAU44712
EAU12735
" posi-