Dyna-Glo M365GMDG14 Manual page 8

ASSEMBLY INSTRUCTIONS
3. Insert 2 screws(AA) into each of the front
holes of the cart left side panel and cart right
side panel(E&F), leaving 4-6mm clearance
from screw head to the side panels (E&F).
Attach the cart front panel (G) by sliding the
keyholes in the cart front panel over the insert-
ed screws and then pushing hard into position.
Secure the cart front panel (G) to the bottom
shelf (A) with 2 screws (AA). Tighten the 4
screws on the side panels (E&F).
Hardware Used
AA M6x12 Screw
4. Insert 2 screws (DD) into each of the rear
holes of the cart left side panel and cart right
side panel (E & F), leaving 4-6mm clearance
from screw head to the side panels (E & F),
and insert 4 screws (DD) into the rear holes of
bottom shelf (A).
Attach the rear corner support for cart (H) by
sliding the cut-outs in the rear corner support
for cart (H) over the inserted screws, pushing
hard into position and tightening all 8 screws (DD).
Now tighten all screws in the cart.
Hardware Used
DD M4x12 Screw
3
E
x 6
4
F
x 8
8
AA
G
A
H
DD
H
E