Emerson Firetrol XG FTA550 Series Assembly, Installation And Operation Instructions page 13

SETTINGS FEATURE SETTINGS
ENABLE
1
Use arrows to enable or disable the user defi ned alarm. Press
ON DELAY
1
Use arrows to select an on delay time before the alarm is acknowledged (0-99 seconds).
Press to confi rm.
AUDIBLE
1
Use arrows to select if the user input activates the audible alarm. Press
COMMON ALARM
Use arrows to select if the user input activates the common alarm output. Press
ON MESSAGE TEXT
Use arrows to program the message that is displayed and recorded when the user defi ned alarm is acti-
vated. Press to confi rm.
OFF MESSAGE TEXT
Use arrows to program the message that is displayed and recorded when the user defi ned alarm is deacti-
vated. Press to confi rm.
SETTINGS
FEATURE SETTINGS
ENABLE
1
Use arrows to enable or disable the cycle interval counter (number of start/stop cycles during a specifi c time
period). Press to confi rm.
DATE FORMAT
Use arrows to select required date format (mm-dd-yyyy, dd-mm-yyyy, yyyy-mm-dd).
Press to confi rm.
START DATE AND TIME
Use
1
Use
1
END DATE AND TIME
Use
1
Use
1
SETTINGS FEATURE SETTINGS
The operator can choose 2 lines of information to be shown on the main screen of the display. Available options are;
stop pressure setting, start pressure setting, cycles/period, cycles/month, cycles/day, cycles/hour, total cycle count,
pump total run time.
Use arrows to select the desired information to be displayed on line 1 (below status and pressure information).
Press to confi rm.
SETTINGS FEATURE SETTINGS
The operator can choose 2 lines of information to be shown on the main screen of the display. Available options are;
stop pressure setting, start pressure setting, cycles/period, cycles/month, cycles/day, cycles/hour, total cycle count,
pump total run time.
Use arrows to select the desired information to be displayed on line 2 (below status and pressure information).
Press to confi rm.
SETTINGS FEATURE SETTINGS
Use arrows to enable or disable the reset cycle counts option. Press
Note: Once cycle counts are reset to zero, the previous cycle counts cannot be recovered.
USER INPUT
1
1
1
CYCLE INTERVAL
1
arrows to select the desired start date. Press
arrows to select the desired start time. Press
arrows to select the desired end date. Press
arrows to select the desired end time. Press
to confi rm.
OPERATORS CHOICE 1
OPERATORS CHOICE 2
RESET CYCLE COUNTS
10
to confi rm.
to confi rm.
to confi rm.
to confi rm.
to confi rm.
to confi rm.
1
1
1
to confi rm.