Error Code / Fault Display / Signal - Siemens S Series User Manual

Fault
Appliance door opens too
wide when activated.

Error code / Fault display / Signal

Fault
E:12 lights up.
E:14 lights up.
E:15 lights up.
E:16 lights up.
E:18 or indicator for water
supply lights up.
Cause
Door is not correctly adjus-
ted.
Cause
Heating element is furred
up.
Water protection system is
activated.
Water protection system is
activated.
Water is continuously run-
ning into the appliance.
Supply hose is kinked.
Water tap is turned off.
Water tap is jammed or
furred up.
Filter in the water supply is
blocked.
Troubleshooting en
Troubleshooting
Adjust the appliance door as de-
▶
scribed in the installation instruc-
tions.
Troubleshooting
Descale the appliance.
1.
Operate the appliance with the Wa-
2.
ter softening system.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 59.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 59.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 59.
Install the supply hose without
▶
kinks.
Turn on the water tap.
▶
Turn on the water tap.
▶
The flow rate must be at least 10 l/
min when the water supply is open.
Switch off the appliance.
1.
Pull out the mains plug.
2.
Turn off the water tap.
3.
Unscrew the water connection.
4.
Remove the filter from the supply
5.
hose
Clean the filter.
6.
47