Advertisement
Activation Started: The connection to Stratocast has started.
Time Synchronization failed: Failed to connect to the Stratocast NTP server.
Registration failed: Failed to register the camera with the Enrollment service.
Device unregistered: The camera has been unregistered.
Device Registered: The camera has been registered with Stratocast.
Balancer failed: Failed to connect to Device Load Balancer.
Device Failed to Connect: Failed to connect to Stratocast.
Device Connected: The camera is connected to Stratocast.
Device Disconnected: The connection between the camera and Stratocast has been lost.
[Software Version]
The version of the camera firmware installed in the camera is displayed.
To register the Genetec Stratocast Service, follow the steps below.
1. Enable the Stratocast connection function.
Select "Enable" in "Stratocast" and click "Set".
•
Note
Do not close this window until the camera registration to Stratocast is completed.
2. Log in to Stratocast.
Click "1 - Get an Activation code for this camera" to connect to the Stratocast portal site with a browser.
•
• Log in using your registered Genetec account.
3. Follow the instructions on the Stratocast portal site to register the camera and obtain an Activation
code.
• Follow the instructions on the Stratocast portal site screen to register the camera.
• Confirm that the MAC address has been entered on the registration screen.
If the MAC address is not entered, enter the MAC address displayed on the camera browser.
(Click the "Copy" button to copy the MAC address to the clipboard.)
• When registration is completed, the Activation code will be displayed.
4. Enter the displayed Activation code on the camera screen to start the Stratocast service.
• Return to the browser screen of the camera, enter the Activation code, and click the "Activate" button.
• Return to the Stratocast portal screen and wait for Stratocast to process (about 5 minutes).
• Follow the instructions on the Stratocast portal screen to start the service.
45
Advertisement
