Touch Screen Calibration; Set Date And Time - Linear 2GIG Go!Control GC2 User Manual

Go!Control Wireless Security System | User Guide
TOUCH SCREEN
CALIBRATION
To calibrate the display, do the following:
From the Home Screen, press Security.
1
From the Security Screen, press Menu.
2
From the Menu Screen, press Toolbox.
3
To access the toolbox, enter a valid User
4
Code.
From Toolbox Screen (1 of 3), press the
5
→ arrow.
From the Toolbox Screen (2 of 3), press
6
Calibrate Touch Screen.
The Touch Screen displays a cross on the
7
screen. Touch the center of the cross.
Repeat with the next 2 crosses that
appear.
When calibration has been successful, a
8
completion screen appears. To finish,
press Ok. This action returns you to the
Toolbox Screen.
36 ©2013 2GIG Technologies Inc. All Rights Reserved.

SET DATE AND TIME

The Control Panel has a built‐in clock and
calendar. The Home Screen displays the time
and date. The time and date are also used
for the system history and event logs that
store data on system events.
NOTE: During installation, your installer can
set the system to automatically adjust for
daylight saving time if it's observed in
your location.
NOTE: The time and date are automatically
set through the cellular radio by the
Central Station if your Control Panel has
a cellular radio installed.
To set the date and time, do the following:
From the Home Screen, press Security.
1
From the Security Screen, press Menu.
2
From the Menu Screen, press Toolbox.
3
From Toolbox Screen (1 of 3), press the
4
→ arrow.
From the Toolbox Screen (2 of 3), press
5
Set Date or Set Time.
Use the ↑ and ↓ arrows to set the
6
current date or time. Press Ok.
A confirmation screen showing the date
and time set appears. Press Ok.